NewTechWood UH02-16-WN-S Guia de Instalação descarregar pdf (Página 5)

UltraShield

Decking Installation Instructions

Decking

Option 2: Screw from the top

1. After calculating the decking span and making the

frame of your deck the ﬁrst board is ready to be

installed.

2. First, mark where you will drill on the top of board as

shown in Diagram 3.

Note: When face fastening the minimum distance is:

A. From the ends of the board 1-1 1/2” (38mm)

B. From the sides of the board 1” (26 mm)

3. Pre-drill a hole for the screw through the board from

above and into the joist.

4. Next, ﬁx the screw into the hole shown in Diagram 4.

5. Repeat steps 1-4 for each joist for the ﬁrst and last

board of your deck.

Note: When making the ﬁnal cuts we recommend

snapping a chalk line and using a circular saw to the

cut the deck boards that ran wild during installation.

Option 3: Starting accessory

1. A starting accessory can be used by ﬁrst drilling the

accessory into the joist.

2. First pre-drill into the joist then ﬁx the starting

accessory into the joist as shown in Diagram 5

3. Then take your ﬁrst board and push it into the

starting accessory as shown in Diagram 5

Diagram 3

Diagram 4

Diagram 5

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

NewTechWood UH02-16-WN-S Guia de Instalação Página 5